ASTM B574 Standard Specification for Low-Carbon Nickel-Chromium-Molybdenum

ASTM B574 Standard Specification for Low-Carbon Nickel-Chromium-Molybdenum, Low-Carbon Nickel-Molybdenum-Chromium-Tantalum, Low-Carbon Nickel-Chromium-Molybdenum-Copper, and Low-Carbon Nickel-Chromium-Molybdenum-Tungsten Alloy Rod

This specifification2 covers rod of low-carbon nickelchromium-molybdenum alloys (UNS N10276, N06022, N06035, N06455, N06058, and N06059)*, low-carbon nickel-molybdenum-chromium-tantalum (UNS N06210), low-carbon nickel-chromium-molybdenum-copper alloy (UNS N06200), and low-carbon nickel-chromium-molybdenum-tungsten (UNS N06686) as shown in Table 1, for use in general corrosive service. 

The following products are covered under this specififi- cation: 

1.2.1 Rods 5⁄16 to 3⁄4 in. (7.94 to 19.05 mm), exclusive, in diameter, hot or cold fifinished, solution annealed and pickled, or mechanically descaled. 

1.2.2 Rods 3⁄4 to 31⁄2 in. (19.05 to 88.9 mm), inclusive, in diameter, hot or cold fifinished, solution annealed, ground or turned. 

1.2.3 Rods 1⁄4 to 3 1⁄2 in. (6.35 to 88.9 mm), inclusive, in diameter, solution annealed, cold fifinished, as cold fifinished, ground or turned (N06059 and N06686 only, see Table 2 and Table 3).

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards

 including those identifified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.