ASTM B466 Standard Specification for Nickel-Chromium-Molybdenum-Columbium Alloy Rod and Bar

ASTM B466 Standard Specification for Nickel-Chromium-Molybdenum-Columbium Alloy (UNS N06625)* Rod and Bar

1.1 This specification covers nickel-chromium-molyb-denum-columbium (UNS NO6625)* in the form of hot-worked rod and bar and cold-worked rod in the conditions shown in Table 1.

1.1.1 These products are furnished in two grades of different heat-treated conditions:

1.1.1.1 Grade 1 (Annealed)——Material is normally em-ployed in service temperatures up to 1100°F (593°C).

1.1.1.2 Grade 2 (Solution Annealed)—Material is normally employed in service temperatures above 1100°F(593°C)when resistance to creep and rupture is required.

Note 1-Hot-working or reannealing may change properties signifi-cantly, depending on working history and temperatures.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 The following precautionary caveat pertains only to the test methods portion, Section 12, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use.It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limita-tions prior to use.