ASTM A351 Standard Specification for Castings, Austenitic, Austenitic-Ferritic (Duplex), for Pressure-Containing Parts

ASTM A351 Standard Specification for Castings, Austenitic, Austenitic-Ferritic (Duplex), for Pressure-Containing Parts

ASTM A351 Standard Specification covers austenitic and austeniticferritic (duplex) steel castings for valves, flflanges, fifittings, and other pressure-containing parts (Note 1). NOTE 1—Carbon steel castings for pressure-containing parts are covered by Specifification A 216/A 216M, and low-alloy steel castings by Specifification A 217/A 217M. 

A number of grades of austenitic and austenitic-ferritic steel castings are included in this specifification. Since these grades possess varying degrees of suitability for service at high temperatures or in corrosive environments, it is the responsibility of the purchaser to determine which grade shall be furnished. Selection will depend on design and service conditions, mechanical properties, and high-temperature or corrosion-resistant characteristics, or both. 

1 Because of thermal instability, Grades CE20N, CF3A, CF3MA, and CF8A are not recommended for service at temperatures above 800°F [425°C]. 

2 Because of embrittlement phases, Grade CD4MCu is not recommended for service at temperatures above 600°F [316°C]. 

The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specififi- cation.